Oracle X7-2 Installation Manual page 61

The slide-rail latching bracket has a green release tab. This tab is used to release and
Note -
remove the latching bracket so that you can remove connector D.
11. Gently tug on the four CMA connection points to ensure that the CMA
connectors are fully seated before you allow the CMA to hang by its own weight.
To verify that the slide-rails and the CMA are operating properly before routing
12.
cables through the CMA:
Ensure that the rack anti-tilt bar is extended to prevent the rack from tipping
a.
forward when the server is extended.
To reduce the risk of personal injury, stabilize the rack cabinet and extend the anti-tilt
Caution -
bar before extending the server from the rack.
For instructions to stabilize the rack, see
b. Slowly pull the server out of the rack until the slide-rails reach their stops.
c. Inspect the attached cables for any binding or kinks.
Install the Cable Management Arm (Optional)
"Stabilize the Rack" on page
Installing the Server Into a Rack
44.
61