Oracle X7-2 Installation Manual page 74

X7-2L Back Panel Connectors and Ports
No.
1
2
3
74 Oracle Servers X7-2 and X7-2L Installation Guide • October 2017
Cable Port or Expansion Slot
Power supply 0 input power
Power supply 1 input power
Network management port (NET MGT)
Ethernet port (NET 0)
Description
The server has two power supply connectors,
one for each power supply.
Do not attach power cables to the power
supplies until you have finished connecting
the data cables to the server. The server goes
into Standby power mode, and the Oracle
ILOM service processor initializes when the
AC power cables are connected to the power
source. System messages might be lost after
60 seconds if the server is not connected to a
terminal, PC, or workstation.
Note - Oracle ILOM will signal a fault
on any installed power supply that is not
connected to an AC power source, since it
might indicate a loss of redundancy.
The service processor NET MGT port is
the optional connection to the Oracle ILOM
service processor. The NET MGT port is
configured by default to use Dynamic Host
Configuration Protocol (DHCP). The service
processor NET MGT port uses an RJ-45
cable for a 10/100/1000BASE-T connection.
The Ethernet port enables you to connect
the system to the network. The Ethernet port