Oracle X7-2 Installation Manual page 60

Install the Cable Management Arm (Optional)
9. To prepare CMA connector D for installation, remove the tape that secures the
slide-rail latching bracket to connector D, and ensure that the latching bracket is
properly aligned with connector D [frames 1 and 2].
Note -
remove the tape before you install this connector.
10. To install CMA connector D into the left slide-rail:
a. While holding the slide-rail latching bracket in place, insert connector D and
its associated slide-rail latching bracket into the left slide-rail until connector
D locks into place with an audible click [frames 1 and 2].
Note -
install connector D and the latching bracket as one assembly into the slide-rail.
Gently tug on the left side of the CMA back slide bar to verify that connector
b.
D is properly seated.
60 Oracle Servers X7-2 and X7-2L Installation Guide • October 2017
The CMA is shipped with the slide-rail latching bracket taped to connector D. You must
When inserting connector D into the slide-rail, the preferred and easier method is to