Oracle X7-2 Installation Manual page 66

Remove the Cable Management Arm
e. Remove the cables from the CMA and set them aside.
To disconnect connector D:
4.
a. Press the green release tab (callout 1) on the slide-rail latching bracket
toward the left and slide the connector D out of the left slide-rail [frames 1
and 2].
When you slide connector D out of the left slide-rail, the slide-rail latching bracket portion
of the connector remains in place. You will disconnect it in the next step.
Note -
Throughout the remainder of this procedure, the CMA must be supported until all the remaining
connectors are disconnected and the CMA can be placed on a flat surface.
66 Oracle Servers X7-2 and X7-2L Installation Guide • October 2017
After you disconnect connector D, do not allow the CMA to hang under its own weight.