Oracle X7-2 Installation Manual page 108

Configure RAID Using RSTe
You can configure the volumes from the BIOS level or from Windows or Linux operating
systems.
Note -
with Oracle ZFS File System.
Configure RAID Using RSTe
This procedure configures a RAID volume so that you can install an operating system.
Note -
1. Access the host console locally or through Oracle ILOM.
For instructions, see
2. Reset or power on the server.
For example, to reset the server:
From the local server, press the Power button on the front panel of the server for
■
approximately 1 second to power off the server, and then press the Power button again to
power on the server.
From the Oracle ILOM web interface, select Host Management → Power Control, and
■
then select Reset from the Select Action list box. Click Save, and then click OK.
From the Oracle ILOM CLI, type: reset /System
■
The power-on self-test (POST) sequence begins.
3.
When prompted in the BIOS screen, press F2 (Ctrl+E from a serial connection) to
launch the BIOS Setup Utility.
Note -
depending on your system equipment and configuration.
108 Oracle Servers X7-2 and X7-2L Installation Guide • October 2017
Oracle Solaris does not support RSTe. You can mirror Oracle Solaris M.2 root volumes
This procedure applies only to servers with SATA M.2 SSDs.
"Accessing Oracle ILOM" on page
The steps and screens in this procedure are examples. What you actually see might differ
84.