Testing Network Settings For Oracle Ilom; Test Ipv4 Or Ipv6 Network Configuration From The Oracle Ilom Cli; Interface - Oracle Sun Server X4-4 Installation Manual

Testing Network Settings for Oracle ILOM

IPv6: To set a static IPv6 address, ensure that the Enabled check box next
■
to the State property is selected. Then, type the static address in the format
ipv6_address/subnet mask length in bits
fec0:a:8:b7:214:4f ff:feca:5f7e/64) and click Save.
4. Test the IPv4 or IPv6 network configuration from Oracle ILOM using the Network
Test Tools (Ping and Ping 6).
For details, see
Interface" on page
Testing Network Settings for Oracle ILOM
The procedures in this section describe how to test Oracle ILOM network settings.
To test network setting from the Oracle ILOM CLI, see
■
Configuration From the Oracle ILOM CLI" on page
To test network settings from the Oracle ILOM web interface, see
■
Network Configuration From the Oracle ILOM Web Interface" on page
Test IPv4 or IPv6 Network Configuration From the
Oracle ILOM CLI
1.
Use the cd command to navigate to the /SP/network/test directory:
->
cd /SP/network/test
2.
At the CLI prompt, type the show command to view the network test targets and
properties.
For example, the following output shows the test target properties.
-> show
/SP/network/test
Targets:
Properties:
ping = (Cannot show property)
ping6 = (Cannot show property)
64 Sun Server X4-4 Installation Guide • October 2015
"Test IPv4 or IPv6 Network Configuration From the Oracle ILOM Web
65.
in the Static IP Address field (for example:
"Test IPv4 or IPv6 Network
64.
"Test IPv4 or IPv6
65.