Parameter Table - YASKAWA L1000H Quick Start Manual

6 Parameter Table

6 Parameter Table
This parameter table shows the most impor-
tant parameters. Refer to the Technical Man-
ual for a complete list of parameters.
Par. Name
Initialization Parameters
Selects which parameters are
Access accessible via the digital operator.
A1-01 Level 0: Operation only
Selection 2: Advanced Access Level
3: Customer Access Level
Resets all parameters to default.
(returns to 0 after initialization)
0:No Initialize
Initialize 1110: User Initialize (The user
A1-03
Parameters must first set user parameter values
and then store them using parame-
ter o2-03)
2220: 2-Wire Initialization
Operation Mode Selection
Reverse
0:Reverse enabled
b1-04 Operation
1:Reverse prohibited
Selection
Switches the output phase order.
Phase Order
b1-14 0:Standard
Selection
1:Switch phase order
DC Injection Braking
DC Sets the frequency at which DC
Injection Injection Braking starts when
b2-01 Braking Ramp to Stop (b1-03 = 0) is
Start selected. If b2-01< E1-09, DC
Frequency Injection Braking starts at E1-09.
Sets the DC Injection Braking cur-
DC
rent as a percentage of the drive
Injection
b2-02 rated current.
Braking
In OLV the DC excitation current is
Current
determined by E2-03.
DC Inj.
Braking
Sets the time of DC Injection Brak-
Time/DC
b2-03 ing at start in units of 0.01 seconds.
Excitation
Disabled when set to 0.00 seconds.
Time at
Start
EN 32
Description
YASKAWA Europe TOEP C710606 91B AC Drive L1000H - Quick Start Guide
Par. Name
DC Inj.
Sets the DC Injection Braking time
Braking
b2-04 at stop. Disabled when set to 0.00
Time at
seconds.
Stop
Acceleration/ Deceleration
Accel Sets the acceleration time 1 from 0
C1-01
Time 1 to the max. output frequency.
Decel Sets the deceleration time 1 from
C1-02
Time 1 the max. output frequency to 0.
C1-03
Accel/Decel Set the accel/decel times 2 to 4 (set
to
Times 2 to 4 like C1-01/02).
C1-08
C2-01 S-Curve 1 S-curve at acceleration start.
C2-02 S-Curve 2 S-curve at acceleration end.
C2-03 S-Curve 3 S-curve at deceleration start.
C2-04 S-Curve 4 S-curve at deceleration end.
Slip Compensation
• Increase if the speed is lower than
Slip Com-
the frequency reference.
C3-01 pensation
• Decrease if the speed is higher
Gain
than the frequency reference.
• Decrease the setting when the slip
Slip Com-
compensation is too slow.
C3-02 pensation
• Increase the setting when the
Delay Time
speed is not stable.
Torque Compensation
• Increase this setting when the
Torque
torque response is slow.
C4-01 Compensa-
• Decrease this setting when speed/
tion Gain
torque oscillations occur.
Torque • Increase this setting when speed /
Compensa- torque oscillations occur.
C4-02
tion Delay • Decrease the setting when the
Time torque response is too slow.
Description