YASKAWA L1000H Quick Start Manual page 39

Monitor
Fault History
U3-01
Lists the most recent fault that occurred
to
through the fourth most recent fault.
U3-04
U3-05
Accumulated operation time at the most recent
to
fault through the fourth most recent fault.
U3-08
U3-09 to Lists the fifth most recent fault that occurred
U3-14 through the tenth most recent fault.
Accumulated operation time at fifth most
U3-15 to
recent fault through the tenth most recent
U3-20
fault.
* The following faults are not recorded in the error log:
CPF00, 01, 02, 03, UV1, and UV2.
Application Monitors
U7-02 Current oil temperature value
Car Load Monitor. Shows the car load value
U7-03 (% of rated motor torque) from previous
travel.
Amount of frequency offset for car load com-
U7-04
pensation
Amount of frequency offset for oil tempera-
U7-05
ture compensation
Torque Reference-Temperature Compensation
U7-06
Factor: Internal calculation value.
U7-07 Leveling Time at previous Up or Down travel.
Minimum possible value for speed, limited by
U7-08 energy saving mode / overload operation func-
tion. Refer to section "Start Up".
DI/DO
Sel.
Digital Input Function Selections
F Not used (Set when a terminal is not used)
14 Fault reset (Reset when turned ON)
External fault; Input mode: N.O. contact /
20 to 2F N.C. contact, Detection mode: Normal/during
operation
80 Nominal speed selection
81 Intermediate speed selection
82 Inspection speed selection
83 Down travel RUN command
YASKAWA Europe TOEP C710606 91B AC Drive L1000H - Quick Start Guide
Description
Description
DI/DO
Sel.
84 Down travel speed
Digital Output Function Selections
During Run (ON: run command is ON or volt-
0
age is being output)
1 Zero Speed
2 Speed Agree
6 Drive Ready
E Fault
F Not used
10 Minor fault (Alarm) (ON: Alarm displayed)
40 Down Valve Control
58 Safe Disable Status
6 Parameter Table
Description
EN 39