YASKAWA L1000H Quick Start Manual page 34

6 Parameter Table
Par. Name
Analog Input Setting
AM Enter value equal to U1-
H4-01 Monitor monitor values. Example: Enter
Selection "103" for U1-03.
Sets terminal AM output voltage
H4-02 AM Gain
equal to 100% monitor value.
Sets terminal AM output voltage
H4-02 AM Bias
equal to 0% monitor value.
Pulse Output Setting
Enter value equal to U-
MP Monitor
H6-06 monitor values. Example: Enter
Sel.
"102" for U1-02.
MP Monitor Sets the number of output pulses
H6-07
Scaling when the monitor is 100% (in Hz).
Motor Overheat Protection
Sets the motor overload protection.
Motor 0:Disabled
L1-01 Overload 1:Standard fan cooled motor
Prot. Sel. 2:Standard blower cooled motor
3:Vector motor
Motor Sets the motor overload protection
L1-02 Overload time in min. Normally no change is
Prot. Time necessary.
Stall Prevention
0:Disabled - Motor accelerates at
active acceleration rate and may
Stall
stall with too heavy load or too
Prevention
short accel time.
Selection
L3-01 1:General Purpose - Hold
during
acceleration when current is
Accelera-
above L3-02.
tion
2:Intelligent - Acceleration in the
shortest possible time.
Stall Prev.
Sets the current level for stall pre-
L3-02 Level dur-
vention during acceleration.
ing Accel.
Stall Prev. 0:Disabled - Deceleration as set.
Selection OV might occur.
L3-04
during 1:General Purpose - Deceleration is
Decel. hold if DC bus voltage rises high.
0:Disabled - Motor stall or
Stall Prev.
overload might occur.
L3-05 Selection
1:Decel Time 1 - Reduce speed
during Run
using C1-02.
EN 34
Description
YASKAWA Europe TOEP C710606 91B AC Drive L1000H - Quick Start Guide
Par. Name
Stall Prev. Sets the current level at which stall
L3-06 Level dur- prevention during run starts to
ing Run operate.
Torque Limit
L7-01
Torque Available in Customer Access
to
Limit Level.
L7-04
Ambient Temperature
Ambient
Available in Customer Access
L8-12 Tempera-
Level.
ture
User Default
User
Available in Customer Access
o2-03 Default
Level.
Selection
Copy Function
o3-01 Copy Func- Available in Customer Access
o3-02 tion Level.
Input Data - Teaching Function
0: Manual Setting,
Hydraulic 1: ISO VG 22,
P1-01 Oil ISO VG 2: ISO VG 32,
Number 3: ISO VG 46,
4: ISO VG 68
Tempera-
P1-02 ture at Manual or preselected by P1-01
100 cSt
Tempera-
P1-03 ture at 25 Manual or preselected by P1-01
cSt
Ram Diam-
P1-04 Elevator data
eter
Number of
P1-05 Elevator data
rams
Suspension
P1-06 Elevator data
ratio
Empty car
P1-07 static pres- Elevator data
sure
P1-08 Pay load Elevator data
Dynamic
P1-09 pressure Elevator data
increase
Description