Renumbering Programs; Editor Settings - Siemens SINUMERIK 840D sl Operating Manual

3.8.5

Renumbering programs

You can modify the block numbering of programs opened in the editor at a later point in time.
Requirement
The program is opened in the editor.
Proceed as follows
Note
If you only want to renumber a section, select the program blocks whose block numbering
you want to edit.
3.8.6

Editor settings

In the "Settings" window enter the default settings for newly rendered programs in the editor.
Presettings
Settings
Number
automatically
First block number
HMI sl Universal
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
1. Press the ">>" softkey.
A new vertical softkey bar appears.
2. Press the "Renumbering" softkey.
The "Renumbering" window appears.
3. Enter the values for the first block number and the increment to be
used for numbering.
4. Press the "OK" softkey.
The program is renumbered.
Description
Yes: A new block number will automatically be assigned after every line
change. In this case, the specifications provided under "First block number"
and "Increment" are applicable.
No: No automatic numbering
Specifies the starting block number of a newly created program.
The field is only editable when "Yes" is available under "Number
automatically".
Machine the workpiece
3.8 Editing programs
75