Siemens SINUMERIK 840D sl Operating Manual page 123

Proceed as follows
...
Several magazines
If you have set up several magazines, then the "...relocate from magazine... location... to..."
window displays after pressing the "Relocate" softkey.
Select the desired magazine and location, and confirm your selection with "OK" to load the
tool.
HMI sl Universal
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
1. Select the "Parameter" operating area.
2. Press the "Magazine" softkey.
3. Position the cursor on the tool that you wish to relocate to a different
magazine location.
4. Press the "Relocate" softkey.
5. The "... relocate from location ... to ..." window appears on the screen.
The "... empty location" field is initialized with the number of the first
empty magazine location.
6. Press the "OK" softkey to relocate the tool to the suggested location.
- OR -
Enter the location number you require and press the "OK" softkey.
- OR -
Press the "Spindle" softkey to load a tool into the spindle and press
the "OK" softkey.
The tool is loaded into the specified magazine location or spindle.
Tool management
7.5 Magazine
123