Entering Parameters - Siemens SINUMERIK 840D sl Operating Manual

1.4.6

Entering parameters

On setting up the machine and during programming, you must enter values in the white
fields for various parameters. Parameters that have a gray input field are automatically
calculated.
Selecting parameters
Some parameters require you to select from a number of options in the input field. Fields of
this type do not allow you to type in a value.
Selecting the unit
For certain parameters, you can choose from among different units.
Proceed as follows
Changing or calculating parameters
If you only want to change individual characters in an input field rather than overwriting the
entire entry, switch to insertion mode. In this mode, the pocket calculator is also active. You
can use it during programming to calculate parameter values.
HMI sl Universal
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
1. Keep pressing the "SELECT" key until your preferred setting or unit
is selected.
The "SELECT" key only works if there are several selection options
available.
2. Enter a numerical value.
3. Press the "INPUT" key to finish the parameter input.
Introduction
1.4 Operator interface
27