Block Selection - Siemens SINUMERIK 840D sl Operating Manual

Teaching in programs

4.5 Block selection

4.5 Block selection
You have the option of setting the interrupt pointer to the current cursor position. The next
time the program is started, processing will resume from this point.
With teach-in, you can also change program areas that have already been executed. This
automatically disables program processing.
You must press reset or select a block to resume the program.
Requirement
The program to be processed is selected.
Proceed as follows
92
1. Select the "Machine" operating area.
2. Press the "AUTO" key.
3. Press the "TEACH IN" key.
4. Press the "Teach prog." softkey.
5. Place the cursor on the desired program block.
6. Press the "Block selection" softkey.
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
HMI sl Universal