• [4] Gear (x1)
• [5] Timing pulley/gear (x1)
• [6] Tension bracket (x2, Spring x1) (Screw
• [7] Clamps (x3)
8. Route the harness [8] through the edge clamp [9] and close it (x1).
9. Connect the harness [10].
10. Reattach the left covers.
Power On
The folder unit must be switched on before the main machine.
1. Switch on the folder unit.
2. Switch on the main machine.
• The folder unit must be switched on first, so that the main machine will recognize the folder unit after
the main machine is powered on and starts its initialization procedure. If the main machine is powered
on before the folder unit, the folder will not operate because it has not been recognized by the main
machine.
is a shoulder screw.)
Manual Feeder (D333)
2
151