Ricoh BE-C1 D046 Field Service Manual page 569

• The Long Print: Graphic mode (this SP) and Long Print: Drawing mode (SP2208-5) are
separate. Drawings are originals with large numbers of fine lines, and Graphics are
originals with graphic images that require more solid shading and fill such as photos.
• If the customer is scanning large numbers of originals that contain graphics, first switch
on SP2208-7 (select "1") then do this SP adjustment to set the percent of coverage.
Long Print Mode Setting
This SP must be switched ON to have the adjustments for SP2208-5 and SP2208-6 enabled
for Fixed Mode (SP2208-3). If the length of the copy exceeds 1250 mm (49.2 in.) the
machine automatically switches to the Fixed Mode (SP208-3).
[0 to 1/0/1]
0: Off: SP2208-5, SP2208-6 adjustments are ignored. In SP2208-3 the default settings are
7
used for 3% or 6% ("1" or "2", whichever is selected).
1: On. After this SP is switched ON:
• The SP2208-5 (Long Print: Drawing) setting will applied to the "1" selection (3%) for
SP2208-3 .
• The SP2208-6 (Long Print: Graphic) setting will be applied to the "2" selection (6%)
for SP2208-3.
2301 Transfer Current Adjustment
These SPs adjust the transfer output power and the transfer output coefficients for the leading
edges, central images, and trailing edges. Adjustments can be done for each type of paper.
SP2301 Settings Table
Source Type
1
2
3 Plain
4
Roll
5
6
7
Trans
8
Location
Before Leading Edge
Leading Edge
Image Area
Trailing Edge
Coefficient
Before Leading Edge
Leading Edge
Image Area
System Service Mode
[Range/Default/Step]
[0 to 230/75/1 uA]
[0 to 230/80/1 uA]
[0 to 230/75/1 uA]
[1 to 2/1/0.1]
[0 to 230/75/1 uA]
[0 to 230/80/1 uA]
8
121