Retrieving The Debug Log From The Hdd - Ricoh BE-C1 D046 Field Service Manual

10
The default settings for Keys 1 to 10 are all zero ("0").
Key to Acronyms
Acronym Meaning
ECS Engine Control Service
GPS GW Print Service
GSP-PM GW Print Service – Print Module
IMH Image Memory Handler
MCS Memory Control Service
NCS Network Control Service
The machine is now set to record the debugging information automatically on the HDD (the target selected
with SP5857-002) for the events that you selected SP5858 and the memory modules selected with
SP5859.
Please keep the following important points in mind when you are doing this setting:
• Note that the number entries for Keys 1 to 5 are the same for the Copy, Printer, Scanner, and Web
memory modules.
• The initial settings are all zero.
• These settings remain in effect until you change them. Be sure to check all the settings, especially the
settings for Keys 6 to 10. To switch off a key setting, enter a zero for that key.
• You can select any number of keys from 1 to 10 (or all) by entering the corresponding 4-digit numbers
from the table.
• You cannot mix settings for the groups (COPY, PRINTER, etc.) for 006 to 010. For example, if you
want to create a PRINTER debug log you must select the settings from the 9 available selections for
the "PRINTER" column only.
• One area of the disk is reserved to store the debug log. The size of this area is limited to 4 MB.

Retrieving the Debug Log from the HDD

Retrieve the debug log by copying it from the hard disk to an SD card.
1. Insert the SD card into the service slot of the copier.
2224 (BCU)
Acronym
NFA
PDL
PTS
SCS
SRM
WebDB
Using the Debug Log
2000 (NCS)
Meaning
Net File Application
Printer Design Language
Print Server
System Control Service
System Resource
Management
Web Document Box
(Document Server)
5
431