Ricoh BE-C1 D046 Field Service Manual page 670

8. Appendix: SP Mode Tables
The width of the folded paper output from the fan folder unit determines the stop position of the
jogger fence for each job, but this distance can be adjusted within ± 5 mm.
Raising or lowering the setting increases or decreases the distance away from the normal stop
position.
[-5 to +5/0/1 mm]
Horizontal Trans Pres Motor Position Adj
The press motor turns on and lowers the guide plate in 1222 steps from when the horizontal
transport guide HP sensor goes OFF and presses the plate down on top of the paper. The
31
pressure position can be adjusted within the range of ±20 steps. Raising or lower the setting
increases or decreases the amount of pressure applied.
[-20 to +20/0/1]
Vertical Feed Speed: High
If the folded paper is fed from the fan folder at a speed of more than 100 mm/s, the line speed
is lowered once the trailing edge of the paper passes the transport entrance sensor. The amount
41
of reduction in the line speed at this point can be adjusted. The table below shows how the
speed is reduced.
These adjustments apply to all standard paper sizes other than A2 LEF.
[-2 to +2/0/1]
8
SP
2
1
0
-1
-2
Vertical Feed Speed: Low
If the folded paper is fed from the fan folder at a speed of more than 100 mm/s, the line speed
is lowered once the trailing edge of the paper passes the transport entrance sensor. The amount
42
of reduction in the line speed at this point can be adjusted. The table below shows how the
speed is reduced.
This adjustment applies to A2 LEF size paper only.
[-2 to +2/0/1]
SP
222
Speed (mm/s) Drive Freq. (pps)
100 (100.626)
90 (89.553)
82.1670
70 (71.153)
58.1
Speed (mm/s) Drive Freq. (pps)
810.9254
721.5262
662.1178
573.4108
468.188