Ricoh BE-C1 D046 Field Service Manual page 47

3. Push in the breaker test button with the tip of the screwdriver, until the breaker snaps to the
'Trip' ("O") position [A].
4. Confirm that the breaker switch is at the 'O' position.
If the breaker switch does not drop to the "O" position:
• Make sure that the power cord is securely connected to the power supply.
• Push the test button again.
• If the breaker switch does not snap down to the 'O' position, the breaker switch must be replaced.
5. Raise the breaker switch to the on ("|") position [B].
• The breaker switch must be at the "|" position for the machine to operate.
Connect the LAN Cable
1. Make sure that the main power switch is off.
Main Machine (D046/D049)
2
45