Ricoh BE-C1 D046 Field Service Manual page 513

Note: The source of this error is the Data Overwrite Security Unit running from an
SD card.
• Turn the main switch off/on and try the operation again.
SC876 D
SC876-1 D
SC876-2 D
SC876-3 D
SC876-4 D
SC876-5 B
Log data errors
These errors occur when the machine tries to acquire the log data immediately
after power on or upon leaving the energy save mode.
Log data error 1
Log data file corrupted
• Do SP5832-4 (HDD Formatting - Job Log)
Log data error 2
There was no data encryption module available when there was an attempt
to set up data encryption. This error can occur at power on, while the machine
is operating, or when the data encryption settings are set up or changed.
• Replace the data encryption board
• Do the set up procedure again
Log data error 3
NVRAM error. The log encryption key was disabled when the machine was
turned on.
• Do SP5832-4 (HDD Formatting - Job Log)
• Disable the log encryption settings
Log data error 4
NVRAM error 2. One of the following occurred:
• Although log encryption has been disabled, the log data file was
encrypted.
• Although the log encryption has been enabled, the log data file was not
encrypted.
• Do SP5832-4 (HDD Formatting - Job Log)
Log data error 5
SC Tables
GW
5
65