Ricoh BE-C1 D046 Field Service Manual page 659

51 Fan Folder Entrance Loop Timing
This SP adjusts the timing of the entrance clutch to increase amount of registration to correct
skew which can occur with paper of short length.
[-5 to +20/0/0.1 mm]
This SP is enabled for the following paper.
(1) Standard Sizes
• A3 SEF
• 11 x 17 SEF
• 12 x 18 SEF
(2) Free Cut
• Paper shorter than 470 mm
6963 Fold Plate Adjustment: Fan Folder DFU
Use these SP's to adjust operation of the fold plates inside the fan folder of the Folder unit.
1 Fold Plate Movement : LEdge
This SP adjusts how far the fold plates descend to guide the leading edge.
[-200 to +200/0/1]
Note:
• An adjustment of 1 step is equivalent to 0.191 mm.
• An adjustment in the "+" direction moves the fold plates closer to the fan fold rollers, and
an adjustment in the "-" direction moves them away from the fan fold rollers.
2 Fold Plate Movement
This SP adjusts how far the fold plates descend to push the paper between the fan fold rollers
to form the folds.
[-400 to +400/0/1]
Note:
• An adjustment of 1 step is equivalent to 0.191 mm.
• An adjustment in the "+" direction moves the fold plates closer to the fan fold rollers, and
an adjustment in the "-" direction moves them away from the fan fold rollers.
11 Fold Plate Halt : LEdge
This SP adjusts when the fold plates pause on the downstroke at the lowest point near the fan
fold rollers after the leading edge of the paper has entered the fan folder mechanism.
System Service Mode
8
211