Ricoh BE-C1 D046 Field Service Manual page 136

2. Installation
Leveling and Docking
2
1. Level the main machine.
• The main machine should already have been leveled (side-to-side) at installation. If the main
machine has not been leveled side-to-side, this must be done before doing the procedure below
(leveling front-to-rear).
• Set the level on the left bottom support À and then on the right bottom Á support.
• Use a wrench to turn the nut on the leg at each corner under the machine to adjust the height.
• The machine should be level (front to rear) on both sides to within ±0.15 mm/m.
134