Ricoh BE-C1 D046 Field Service Manual page 192

2. Installation
To insert a board:
2
1. With your fingers, loosen the top and bottom screws of the cover [1].
2. Discard the cover.
3. Insert the board [2] in the slot.
4. With your fingers, tighten the top and bottom screws.
• Finger-tighten the screws attached to the board. Do not use a screw driver. If the screws are too
tight, this could twist and damage the board.
Moving Applications on to One SD Card
There are only two SD card slots:
• Slot 1. Insert the application card in this slot. If more than one application is needed, the applications
must be moved to one SD card with SP5873-1.
• Slot 2. This is the service slot used for updating the firmware. Also, the VM card application must reside
in this slot.
Here are some important points you should keep in mind about SD cards and their applications:
• The data necessary for authentication is transferred with the application program to the target SD
card.
• Do not use an SD card if it has previously been used with a computer. Correct operation is not
guaranteed if such an SD card is used.
• The SD card is the only evidence that the customer is licensed to use the application program. The
service technician may occasionally need to check the SD card and its contents to solve problems.
Although copied SD cards are disabled for use, they must be stored at the customer site as proof of
purchase.
190