System Cover Removal / Installation; System Cover Removal; System Cover Installation; Figure 24. System Cover Removal - Intel R2000WF series Service Manual

Intel® Server System R2000WF Product Family System Integration and Service Guide
2.2

System Cover Removal / Installation

2.2.1

System Cover Removal

The server system must be operated with the system cover in place to ensure proper cooling. The top cover
must be removed to add or replace components inside of the system. Before removing the top cover, power
down the system and unplug all peripheral devices and the power cable(s).
Note: A non-skid surface or a stop behind the server system may be needed to prevent the server system
from sliding on your work surface. A screw driver may be needed to loosen the top cover thumb screws.
1. Loosen the two captive thumb screws located on the back edge of the system cover (See Letter 'A')
2. Slide cover back and lift upward (see Letter 'B').
2.2.2

System Cover Installation

1. Place the system cover onto the chassis and slide forward until the front edge of the system cover is
pressed up against the back edge of the front drive bay. (See letter 'B')
2. Hand tighten the two captive thumb screws at the back of the chassis (see letter 'A')
Note: For safety after performing service inside of the system, the top cover must be reinstalled and the
thumbscrews tightened to 8in/lb torque or to where the use of a tool is required to re-enter the server.
34

Figure 24. System Cover Removal

Figure 25. System Cover Installation