3.5" Hdd/Ssd Drive Carrier Assembly; Figure 56. 2.5" Drive Carrier Assembly - Alignment Features; Figure 57. 3.5" Drive Carrier Assembly - Drive / Drive Blank Removal - Intel R2000WF series Service Manual

Intel ® Server System R2000WF Product Family System Integration and Service Guide
Note: The 2.5" drive blank and drive carrier each have an alignment feature (shown above) to ensure proper
assembly. When re-installing a drive blank in to the drive carrier, ensure the features are aligned prior to
installation. Failure to properly install a drive blank may result with the carrier assembly not fitting properly
in to the chassis drive bay.
2.7.4

3.5" HDD/SSD Drive Carrier Assembly

Figure 57. 3.5" Drive Carrier Assembly - Drive / Drive Blank Removal

1. Remove the drive or drive blank from the carrier by holding the carrier assembly top side down in your
right hand. Using your left hand, gently rotate the bottom edge of the left rail upwards (see Letter "A")
while at the same time pushing the drive or drive blank down away from the carrier (see Letter "B").
Figure 56. 2.5" Drive Carrier Assembly – Alignment Features
51