Replacing The Server Board; Server Board Removal; Figure 138. Server Board Removal - Intel R2000WF series Service Manual

Intel® Server System R2000WF Product Family System Integration and Service Guide
11. Carefully place the system on its side and secure the bottom of the I/O module bay to the chassis using
three (3) screws (8 in/lbf torque) (see Letter 'D').
12. Re-attach all cables described in steps 5 & 6 of the removal process.
13. Install system fan module (see Section 2.4.2).
14. Install air duct (see Section 2.3.2).
7.6

Replacing the Server Board

7.6.1

Server Board Removal

1. Power off system and remove power cords from each power supply module installed.
2. Disconnect all externally attached cables.
3. Remove the system cover (see Section 2.2.1).
4. Remove power supply modules (see Section 3.1.2).
5. If installed, remove all cables from devices mounted to the air duct.
6. Remove air duct (see Section 2.3.1).
7. Remove System Fan Module (see Section 2.4.1).
8. Disconnect all cables attached to add-in PCIe add-cards and I/O modules.
9. Remove riser card assemblies (see Section 2.9.1).
10. Remove all options installed onto the server board including (if installed): OCP module, Intel® SAS RAID
Module, Intel® RAID 5 option key, Intel® RMM 4 Lite key, TPM Module, eUSB SSD.
11. Remove processors (see Section 2.5.3).
12. Remove all DIMMs (see section 2.6.2).
13. Disconnect and clear from the server board area all cables attached to connectors on the server board
14. Remove the two air duct sidewalls located on each side of the server board.
15. Remove nine screws used to secure the server board to the chassis (see Letter 'A').
16. Carefully lift the server board from the chassis and place it into an anti-static bag.
122

Figure 138. Server Board Removal