Internal Fixed Mount Sata Ssd - Installation / Removal; Internal Fixed Mount Solid State Drive Installation; Figure 64. Peripheral Device Power Cable; Figure 65. Onboard Peripheral Power And Sata Connectors For Internal Ssd Support - Intel R2000WF series Service Manual
Hide thumbs
Also See for R2000WF series:
- Technical product specification (167 pages) ,
- Configuration manual (127 pages) ,
- Configuration manual (104 pages)
Table of Contents
Advertisement
Intel
®
Server System R2000WF Product Family System Integration and Service Guide
2.8
Internal Fixed Mount SATA SSD – Installation / Removal
The system has support for up to two internal fixed mounted SATA Solid State Devices (SSDs). SSD's can be
mounted to either of the two available air duct options (Standard or High Air Flow). SSD installation and
removal procedures are the same for both air ducts.
2.8.1
Internal Fixed Mount Solid State Drive Installation
1.
From the system's accessory kit, locate the peripheral device power cable.
Figure 65. Onboard Peripheral Power and SATA Connectors for Internal SSD support
2.
Connect the 2x3 cable connector (labeled "SB") to the server board "Peripheral PWR" connector
3.
Locate the SATA cable and install it to either the "SATA 4" or "SATA 5" ports on the server board
Figure 64. Peripheral Device Power Cable
55
Advertisement
Table of Contents
