Figure 18. Dual 8X2.5" Hot Swap Backplane I 2 C Jumper Cable Installation; Figure 19. Sata Cable - Intel R2000WF series Service Manual

Intel ® Server System R2000WF Product Family System Integration and Service Guide
If more than one 8 x 2.5" backplane is being installed, locate the I
cable to the I 2 C -OUT connector of backplane #1 and the other end of the cable to the I
backplane #2.
Figure 18. Dual 8x2.5" Hot Swap Backplane I
3. Connect the SAS/SATA Data Cable(s)
SAS/SATA Data cable connections will vary depending on the system configuration. This section will only
describe cable connections when using the onboard SATA controllers. For other add-in storage options,
refer to the appropriate option installation sections available in this document.
a) Locate the appropriate SAS/SATA Data cables.
b) Attach one side of the SAS/SATA Data cables to the mini-SAS HD connectors on the backplane.
c) Route the SAS/SATA DATA cables from the backplane to the back of the system via the cable
channels next to the chassis sidewalls.
2
2 C Jumper Cable Installation

Figure 19. SATA Cable

C jumper cable and connect one end of the
2 C - IN connector of
29