2.5" Hdd / Ssd Drive Carrier Assembly; Figure 54. 2.5" Drive Carrier Assembly - Drive / Drive Blank Removal; Figure 55. 2.5" Drive Carrier Assembly - Drive Installation To Carrier - Intel R2000WF series Service Manual

Intel® Server System R2000WF Product Family System Integration and Service Guide
2.7.3

2.5" HDD / SSD Drive Carrier Assembly

Figure 54. 2.5" Drive Carrier Assembly – Drive / Drive Blank Removal
1. Remove the drive or drive blank from the carrier by gently rotating the top edge of a carrier rail outwards
while at the same time pushing the drive or drive blank up from the bottom (as shown above).
Mounting Holes
(2 on each side)
Figure 55. 2.5" Drive Carrier Assembly – Drive Installation to Carrier
2. With the rear drive connector positioned towards the back of the drive carrier, align and position the
mounting holes on one side of the drive over the mounting tabs located on the drive carrier side rail (See
letter "A")
3. Lower the other side of the drive into the carrier (See letter "B") and press down on the drive until all
mounting tabs are locked in place.
50
Mounting Tab
(2 on each side)