Replacing The Server Board (Compute Node Tray Assembly); Preparing To Remove The Compute Node Tray Assembly; Removing The Compute Node Tray Assembly; Installing The Compute Node Tray Assembly - Intel R2600SR Series Setup And Service Manual

3.10 Replacing the Server Board (Compute Node Tray Assembly)

The server board field replaceable unit (FRU) consists of the compute node sheet metal tray with cover and
the server board (compute node tray assembly). Replacing the server board consists of removing all
components of the compute node and returning the server board and compute node tray with cover.
3.10.1

Preparing to Remove the Compute Node Tray Assembly

Complete the following steps to prepare the compute node for replacement of the compute node tray
assembly.
 Back up all compute node settings, including the settings for any options installed in the
compute node.
 Before replacing the tray, update the compute node with the latest firmware or restore the pre-
existing firmware. Make sure a copy of the latest or pre-existing firmware is on hand before proceeding
(see Section 2.4). For updating the UUID and the DMI/SMBIOS data, see Section 3.12.1).
3.10.2

Removing the Compute Node Tray Assembly

Follow these steps to remove the compute node tray assembly:
1. Turn off the corresponding compute node that has the server board to be replaced.
2. Remove the compute node (see Section 3.11).
3. Remove the compute node cover (see Section 3.1.3).
4. Remove any of the following components if installed on the compute node:
 Air Baffle (see Section 3.2)
 Dual Inline Memory Modules (DIMMs) (see Section 3.5)
 KVM Module (see Section 3.9)

Solid State Drive (SSD) (see Section 3.7)
 Drive Backplane (see Section 3.8)
 Complementary Metal-Oxide Semiconductor (CMOS) Battery (see Section 3.3)

Processor Heat Sink Module (see Section 3.4)
3.10.3

Installing the Compute Node Tray Assembly

Follow these steps to install the compute node tray assembly:
Note: The components are re-installed in the reverse order in which they were removed.
1. Re-install any components removed from the compute node being replaced:
 Processor Heat Sink Module (see Section 3.4.6)
 Complementary Metal-Oxide Semiconductor (CMOS) Battery (see Section 3.3)

Drive Backplane (see Section 3.8.2)
 Solid State Drive (SSD) (see Section 3.7.2)
 KVM Module (see Section 3.9.2)

Memory Modules (DIMMs) (see Section 3.5)
 Air Baffle (see Section 3.2.1)
2. Reinstall the compute node cover (see Section 3.1.4).
3. Reinstall the compute node (see Section 3.1.2).
4. Update the Universal Unique Identifier (UUID). (see Section 3.11.1).
5. Update the SMBIOS/DMI information. (see Section 3.11.2).
6. Enable the Trusted Platform Module (TPM). (see Section 3.11.3).
42
Intel® Server System R2600SR Setup and Service Guide