Test Operation Mode In Mr Configurator2 - Mitsubishi MR-JE-10B Instruction Manual

4. STARTUP

4.5.1 Test operation mode in MR Configurator2

(1) Test operation mode
(a) JOG operation
JOG operation can be performed without using the servo system controller. Use this operation with
the forced stop reset. This operation may be used independently of whether the servo is on or off
and whether the servo system controller is connected or not.
Exercise control on the JOG operation screen of MR Configurator2.
1) Operation pattern
2) Operation method
The check box "Rotation only while the CCW or CW button is being pushed" is checked.
The check box "Rotation only while the CCW or CW button is being pushed" is unchecked.
POINT
When "_ _ 1 _" is set in [Pr. PC05] to enable the test operation mode, the
SSCNET III/H communication for the servo amplifier in the test operation mode
and the following servo amplifiers is blocked.
When setting [Pr. PC05] to "_ _ 1 _", set it via CN5 (USB connector). When
setting it, disconnect the SSCNET III cable or turn off the power supply of the
controller.
Item
Speed [r/min]
Acceleration/deceleration
time constant [ms]
Operation
Forward rotation start
Reverse rotation start
Stop
Forced stop
Operation
Forward rotation start
Reverse rotation start
Stop
Forced stop
Initial value
200
1000
Keep pressing "Forward CCW".
Keep pressing "Reverse CW".
Release "Forward CCW" or "Reverse CW".
4 - 12
Setting range
0 to maximum speed
0 to 50000
Screen control
Click "Forced Stop".
Screen control
Click "Forward CCW".
Click "Reverse CW".
Click "Stop".
Click "Forced Stop".