Mitsubishi MR-JE-10B Instruction Manual page 25

1. FUNCTIONS AND CONFIGURATION
(2) MR-JE-200B or more
(5)
(6)
Side
(7)
(11)
(12)
(14)
No.
(1) (2)
(1)
(3)
(2)
(3)
(4)
(4)
(5)
(9)
(6)
(10)
(7)
(8)
(13)
(9)
(8)
(10)
(11)
(12)
(13)
(14)
1 - 10
Name/Application
Display
The 3-digit, 7-segment LED shows the servo status and the
alarm number.
Axis selection rotary switch (SW1)
Used to set the axis number of the servo amplifier.
USB communication connector (CN5)
Used to connect this connector to a personal computer.
I/O signal connector (CN3)
Used to connect digital I/O signals.
Power connector (CNP1)
Used to connect the input power supply and regenerative
option.
Rating plate
Battery holder
Used to house the battery for absolute position data
backup.
Battery connector (CN4)
Used to connect the battery for absolute position data
backup.
SSCNET III cable connector (CN1A)
Used to connect the servo system controller or the previous
axis servo amplifier.
SSCNET III cable connector (CN1B)
Used to connect the next axis servo amplifier. For the final
axis, put a cap.
Servo motor power connector (CNP2)
Used to connect the servo motor.
Charge lamp
When the main circuit is charged, this lamp will light up.
While this lamp is lit, do not reconnect the cables.
Encoder connector (CN2)
Used to connect the servo motor encoder.
Protective earth (PE) terminal
Detailed
explanation
Section
4.3
Section
11.4
Section
3.2
Section
3.4
Section
3.1
Section
3.3
Section
1.6
Chapter
12
Section
3.2
Section
3.4
Section
3.1
Section
3.3
Section
3.4
Section
3.1
Section
3.3