Mitsubishi MR-JE-10B Instruction Manual page 110

5. PARAMETERS
No. Symbol
PA20 *TDS Tough drive setting
Alarms may not be avoided with the tough drive function depending on the situations of the
power supply and load fluctuation.
You can assign MTTR (During tough drive) to the CN3-13 pin with [Pr. PD07].
Setting
digit
_ _ _ x
_ _ x _
_ x _ _
x _ _ _
PA21 *AOP3 Function selection A-3
Setting
digit
_ _ _ x
_ _ x _
_ x _ _
x _ _ _
Name and function
Explanation
For manufacturer setting
Vibration tough drive selection
0: Disabled
1: Enabled
Selecting "1" suppresses vibrations by automatically changing
setting values of [Pr. PB13 Machine resonance suppression filter 1]
and [Pr. PB15 Machine resonance suppression filter 2] in case that
the vibration exceeds the value of the oscillation level set in [Pr.
PF23].
Refer to section 7.3 for details.
Instantaneous power failure tough drive selection
0: Disabled
1: Enabled
Selecting "1" avoids triggering [AL. 10 Undervoltage] using the
electrical energy charged in the capacitor in case that an
instantaneous power failure occurs during operation. In [Pr. PF25
Instantaneous power failure tough drive - Detection time], set the
time until the occurrence of [AL. 10.1 Voltage drop in the power].
When "1" is selected for this digit, the power should be off for the
setting value of [Pr. PF25] + 1 s or longer before the power is
cycled to enable a parameter whose symbol is preceded by "*" or
"**".
For manufacturer setting
Explanation
One-touch tuning function selection
0: Disabled
1: Enabled
When the digit is "0", the one-touch tuning with MR Configurator2
will be disabled.
For manufacturer setting
5 - 15
Initial
Setting
value
range
[unit]
Refer to the
"Name and
function" column.
Initial
value
0h
0h
0h
0h
Refer to the
"Name and
Initial
function" column.
value
1h
0h
0h
0h