Panasonic KX-NS500 Features Manual page 538

5.5.4 DSP Resource Usage
Service
DSP Cost = Number of Ports ´ Resource cost per port (unit) ´ Load
*1
In the example above, the total DSP cost is 18.55. In such an environment, a PBX with a DSP S card (max.
63 DSP resources) would be sufficient.
Example 2: Call Centre
In a call centre, both the number of trunks and number of extensions are likely to be very high. Also, since
employees are constantly receiving calls, the system load will be high. Furthermore, calls are often recorded
at call centres to provide quality-of-service monitoring.
Service
Trunk using G.729 codec
Trunk using G.711 codec
Extension using G.729 codec
Extension using G.711 codec
IP-CS using G.729 codec
Unified Messaging
Two-way Recording
OGM
Conference
DSP Cost = Number of Ports ´ Resource cost per port (unit) ´ Load
*1
In this example, the total DSP cost is 188.8. In such an environment, a PBX with a DSP L card (max. 254 DSP
resources) would be sufficient.
Conditions
•
Calls that are established via P2P (® 5.2.3 Peer-to-Peer (P2P) Connection) do not use the PBX's DSP
resources, so they may be excluded from the usage calculation.
PC Programming Manual References
9.38 PBX Configuration—[1-5] Configuration—DSP Resource
538 Feature Guide
Number of Ports Load (Busy Ratio %)
Number of Ports Load (Busy Ratio %)
8
64
32
64
8
8
4
4
12
Total DSP Cost
50%
80%
50%
80%
50%
—
—
—
—
Total DSP Cost
DSP Cost
*1
18.55
DSP Cost
*1
8.8
51.2
35.2
51.2
8.8
10.4
9.2
8.0
6.0
188.8