Panasonic KX-NS500 Features Manual page 276

2.23.2 Room Status Control
[Example Use: Checked-in Mode]
When in Room Status Control mode, the hotel operator's extension is treated as a busy extension, similar to
when performing PT programming. Callers to that extension will hear a busy tone.
All other operations, including pressing other Room Status Control buttons, will be ignored. In addition, the
lights of fixed and flexible buttons do not show their normal display pattern. In order to perform other operations,
the hotel operator must exit Room Status Control mode.
Conditions
CAUTION
If the Call Log for Built-in ACD Report setting for the Supervisory Monitor (ACD) Control feature is enabled
through system programming, this feature cannot be used. For details, refer to the relevant chapter in the
PC Programming Manual or consult your system administrator.
•
SVM voice messages and messages left on the extension's Voice Mail (VM) will be cleared at Check-out.
•
A maximum of four hotel operators can be assigned.
•
Only one of each type of Room Status Control button can be assigned.
•
Extensions associated with rooms must be one of the following types:
PT, KX-UT SIP, general SIP, SLT, ISDN Extension
PSs cannot be checked in and out as room extensions.
•
It is recommended that the extension number of a room extension is the same or similar to the room
number, for convenience.
•
The previous guest's billing data is only cleared when an extension is set back to Check-in status. Thus,
it is possible to edit guest charge data and reprint the bill at any time until another guest is checked in to
the same room.
•
If enabled through system programming, the check-in and check-out information is recorded on SMDR.
PC Programming Manual References
11.5.3 PBX Configuration—[3-5-3] Group—Incoming Call Distribution Group—Miscellaneous—
Options—Call Log for Built-in ACD Report
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button—
14.2 PBX Configuration—[6-2] Feature—Hotel & Charge
→Main— Hotel Operator—Extension 1–4
→Bill— Checkout Billing—Billing for Guest
Feature Guide References
2.2.2.10 Supervisory Feature (ACD)
2.6.3 Last Number Redial
2.7.3 Extension Dial Lock
2.22.1.1 Station Message Detail Recording (SMDR)
2.24.4 Timed Reminder
276 Feature Guide
DSS button
Check-in button
Check-out button
Cleaned-up button
Room101
Rooms 101 and 103
are currently in
Room102
checked-in status.
Room103
Room104
Room105
Type