Panasonic KX-NS500 Features Manual page 209

DISA Intercept Routing—No Answer
If a destination is not available to answer a DISA call within a preprogrammed time period (DISA Intercept time)
after the call is reached, the call will be redirected to the programmed destination by the Intercept feature.
If the intercept destination is not available to answer the call within a preprogrammed time period (DISA
Disconnect Time after Intercept) after the DISA Intercept time expires, the call will be disconnected.
10.3 PBX Configuration—[2-3] System—Timers & Counters—DISA / Door / Reminder / U. Conf
→
DISA—Intercept Timer—Day (s), Lunch (s), Break (s), Night (s)
→
DISA—Disconnect Timer after Intercept (s)
® 12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—Intercept
Destination— Intercept Destination—When called party does not answer—Day, Lunch, Break, Night
® 12.2.1 PBX Configuration—[4-2-1] Extension—Portable Station—Extension Settings—Intercept
Destination— Intercept Destination—When called party does not answer—Day, Lunch, Break, Night
Walking COS Through DISA
If the caller performs Walking COS (extension number and PIN entry) while hearing a DISA message, the
security mode can be temporarily changed to No Security mode (® 2.7.5 Walking COS). After performing
Walking COS, the following features are available, using the settings of the specified extension:
•
Intercom call
•
TIE line call
•
Trunk call
•
Call Forwarding (FWD)/Do Not Disturb (DND) setting (® 2.3 Call Forwarding (FWD)/Do Not Disturb (DND)
Features)
•
Incoming Call Distribution Group Log-in/Log-out (® 2.2.2.8 Log-in/Log-out)
•
Absent Message setting (® 2.20.2 Absent Message)
•
Extension Dial Lock (® 2.7.3 Extension Dial Lock)
•
Time Service Switching Mode (® 5.1.4 Time Service)
Note
When making a trunk call using Walking COS through DISA, the CLIP number for that call will be that of
the extension seized by Walking COS. (® 4.1.2.2 Calling/Connected Line Identification Presentation
(CLIP/COLP))
DISA Automatic Walking COS
Registered outside destinations such as cellular phones can be automatically recognised as PBX extensions
when calling through DISA. When the Caller ID of a received trunk call matches an entry in the System Speed
Dialling Table, the calling telephone is given Walking COS authorisation as assigned to the corresponding CLI
destination extension. Therefore, the "CLI destination" setting in the System Speed Dialling Table is used here
to specify the target extension that the calling telephone will be recognised as for Walking COS.
[Programming Example of DIL Table]
Trunk No.
Day
01 Disable
: :
"CLI" must be set to Disable, to allow incoming calls to be received by DISA.
[Programming Example of System Speed Dialling Table]
CLI
Lunch ...
Disable ...
: :
2.16.1 Direct Inward System Access (DISA)
Destination
Day Lunch
5801 5801
(DISA) (DISA)
: :
...
...
:
Feature Guide 209