WEG CFW100 Programming Manual page 70

V V W Vector Control
For better visualization of the start-up in the V V W mode, check
Seq Action/Indication on the Display
1
Monitoring mode.
„
Press this key
„
3
Press the key
„
Control Type" to P202 = 5 (V V W ). Use the key
5
If necessary, change the content of "P399 – Motor Rated
„
Efficiency" according to data on the nameplate.
Press the key
„
8
If necessary, change the content of "P401 – Motor Rated
„
Current".
Press the key
„
10
If necessary, change the content of "P403 – Motor Rated
„
Frequency".
Press the key
„
12
If necessary, change the content of "P407 – Motor Rated
„
10 Power Factor".
Press the key
„
10-6 | CFW100
to enter the first level of the setting mode.
to change the content of "P202 –
for the next parameter.
for the next parameter.
for the next parameter.
for the next parameter.
Figure 10.2: Start-up of the V V W mode
Figure 10.2 on page
Seq Action/Indication on the Display
2
Press the keys
„
4
Press the key
„
.
Use the keys
„
6
If necessary, change the content of "P400 – Motor Rated
„
Voltage".
Press the key
„
9
If necessary, change the content of "P402 – Motor Rated
„
Speed".
Press the key
„
11
If necessary, change the content of "P404 – Motor Rated
„
Output".
Press the key
„
13
If necessary, change the content of "P409 – Stator Resistance".
„
Return Advance
10-6, below:
or until selecting parameter P202.
to save the change of P202.
until selecting parameter P399.
for the next parameter.
for the next parameter.
for the next parameter.