WEG CFW100 Programming Manual page 30

HMI and Basic Programming
It is the initial status of the HMI after the successful power-up (without fault,
„
alarms or undervoltages).
Press the key to go to level 1 of the setting mode – parameter selection.
„
Pressing any other key will also change to the setting mode.
Level 1:
This is the first level of the setting mode. The number of the parameter is shown
„
on the main display.
Use the and
„
Press the key to go to level 2 of the setting mode – modification of the
„
parameter content.
Level 2:
4
The content of the parameter is shown on the main display.
„
Use the and
„
Press the key to confirm the modification (save the new value). After the change
„
is confirmed, the HMI returns to level 1 of the setting mode.
NOTE!
When the inverter is in the fault state, the main display indicates the number of the fault in the format
Fxxx. The browsing is allowed after pressing the
NOTE!
When the inverter is in the alarm state, the main display indicates the number of the alarm in the format
Axxx. The browsing is allowed after pressing the
the Unit of measurement display, flashing until the situation causing the alarm is solved.
4-2 | CFW100
Start-up Mode
Setting Mode
keys to find the desired parameter.
keys to confi gure the new value for the selected parameter.
Figure 4.3: HMI operating modes
key.
key, and then the indication "A" is displayed on
Return Advance
Monitoring
Parameterization
Level 1
Parameterization
Level 2