WEG CFW100 Programming Manual page 109

P011 – Active Current
Adjustable -10.0 to 10.0 A
Range:
Properties: ro
Description:
It indicates the active current in the inverter output in amperes RMS (Arms).
P012 – Digital Input Status
Refer to section 12.5 DIGITAL INPUT on page
P013 – Digital Output Status
Refer to section 12.7 DIGITAL OUTPUTS on page
P018 – Analog Input Value AI1
Refer to section 12.1 ANALOG INPUTS on page
P022 – Frequency Input Value FI in Hz
Refer to section 12.4 FREQUENCY INPUT on page
P023 – Version of Main Software
P029 – Power Hardware Configuration
Refer to section 6.1 INVERTER DATA on page
P030 – Power Module Temperature
Adjustable -200.0 to 200.0 ºC
Range:
Properties: ro
Description:
Temperature in ºC measured inside the power module by the internal NTC.
P037 – Motor Overload Ixt
Refer to section 13.1 MOTOR OVERLOAD PROTECTION (F072 AND A046) on page
P047 – CONFIG Status
Adjustable
0 to 999
Range:
Properties:
ro
Description:
This parameter shows the origin situation of CONFIG mode. Refer to
STATUS on page 5-5.
12-8.
12-16.
12-1.
12-6.
6-1.
Return Advance
Reading Parameters
Factory
Setting:
Factory
Setting:
13-1.
Factory
Setting:
section 5.3 SITUATIONS FOR CONFIG
14
CFW100 | 14-3