Safety Compliance - Tektronix WVR7200 Installation And Safety Manual

Australia / New Zealand
Declaration of
Conformity – EMC

Safety Compliance

EC Declaration of
Conformity – Low Voltage
U.S. Nationally Recognized
Testing Laboratory Listing
Canadian Certification
Additional Compliances
Equipment Type
Safety Class
Pollution Degree
Description
WVR7200 Installation and Safety Instructions
Complies with the EMC provision of the Radiocommunications Act per the
following standard, in accordance with ACMA:
EN 55022:1987. Radiated and conducted emissions, Class B, in accordance
with EN 55103-1:1996.
Compliance was demonstrated to the following specification as listed in the
Official Journal of the European Communities:
Low Voltage Directive 2006/95/EC.
EN 61010-1: 2001. Safety requirements for electrical equipment for
measurement control and laboratory use.
UL 61010-1:2004, 2
equipment.
CAN/CSA-C22.2 No. 61010-1:2004. Safety requirements for electrical
equipment for measurement, control, and laboratory use. Part 1.
IEC 61010-1: 2001. Safety requirements for electrical equipment for
measurement, control, and laboratory use.
Test and measuring equipment.
Class 1 – grounded product.
A measure of the contaminants that could occur in the environment around
and within a product. Typically the internal environment inside a product is
considered to be the same as the external. Products should be used only in the
environment for which they are rated.
Pollution Degree 1. No pollution or only dry, nonconductive pollution occurs.
Products in this category are generally encapsulated, hermetically sealed, or
located in clean rooms.
Pollution Degree 2. Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused by condensation must
be expected. This location is a typical office/home environment. Temporary
condensation occurs only when the product is out of service.
Edition. Standard for electrical measuring and test
nd
Compliance Information
5