Autogeofencing Settings - Teltonika FM1000 ST User Manual

Y1 – geofence zone left bottom corner Y coordinate (latitude);
X2 or R – geofence zone upper right corner X coordinate (longitude) or radius of circle
when Circular zone is used (radius in meters);
Y2 – geofence zone upper right corner Y coordinate (latitude).

5.11.4 AutoGeofencing settings

AutoGeofence – the last known position after movement = off ("X on Stop Mode"). If your
car's being taken away – you can be notified. The shape and size of the geofence zones are
parameters. It is possibility to state whether entering in or out of the geofence triggers an
asynchronous message.
AutoGeofencing option can be configured by following parameters visible in figure 28
below.
Activate – Enable or Disable AutoGeofence functionality.
Activation TMO – Time period before Geofence is activated after vehicle stops.
Priority – Priority of generated event, which will be applied to saved record.
Enter Event – Event generation on Geofence entrance.
Exit Event – Event generation on Geofence exit.
On Both – Event generation on Geofence entrance Or exit.
Deactivated By – Autogeofence can be deactivate via Power voltage, DIN1, OBD detection.
Note that AutoGeofencing does not require entering coordinates, instead it requires GNSS
visibility. If vehicle stopped and activation timeout has passed, an AutoGeofence will be created
around vehicle's last position with set Radius value. AutoGeofence event generation works the
same as Geofencing mentioned above.
Figure 27 Geofence configuration
39