Record Storage; System Settings - Teltonika FM1000 ST User Manual

Keyword is 4 – 10 symbol length. If keyword is set, every time user reconnects FM1000 to
USB port, user will be asked to provide valid keyword when connecting FM1000 to configurator.
User is given 5 attempts to enter keyword. After entering valid keyword, counter resets to 5.
If user disconnects FM1000 using 'Disconnect' button and does not disconnect from USB
port, after reconnecting using 'Connect' button, configurator does not ask for keyword.
ATTENTION! If you have entered a keyword, disconnected from the
configurator and then later connected again, you will need to enter the
keyword that you have entered previously. If you have forgotten it, please
contact your local sales manager.
5.7

Record storage

FM1000 can store up to 8000 data records if GSM or GPRS is not available at the moment.
It will send data later when GPRS is available again. Note that FM1000 can have memory full of
records. In such case it will start deleting oldest records in order to save new ones. Sending all
the data records to server may take some time. Sending 8000 records for FM1000 may take for
about 2 hours (exact time may differ depending on GPRS/server load).
You can access all uploaded data from TAVL4 application.
More details on how to use TAVL application please refer to "TAVL4 application user
manual" documentation.
5.8

System settings

System settings have 6 configurable parameters:
Sleep settings, where user can turn sleep/deep sleep on or off;
Mode Switch Settings, where user can configure 3 ways how FM1000 will change its
working mode;
Ignition Settings, where user can configure ignition detection source (for ignition source).
Ignition Source can be selected as Power Voltage, Digital Input 1, Movement or OBD. This
parameter has influence on all FM1000 application. If ignition source is set to Power Voltage
ranges for ignition detection must be configured. Ignition is set to 1 when Power Voltage is in
range between Low & High Power Voltage Levels. If ignition source is set to OBD, FM will check
ignition state according by RPM value. While RPM is unavailable, Ignition Source Settings are
working like in Power Voltage mode.
Static Navigation – when this parameter is enabled, FM1000 filters out GPS jumps,
when vehicle is not moving. When it is disabled, it does not make any changes to collected GPS
data.
Records Settings, where user can turn on saving/sending without time
synchronization.
LED Settings, where user can enable/disable LED indication (both – GSM and GPS).
This configuration parameter is saved in FLASH and when LED indication is disabled and device is
turned on, indication will be enabled until configuration will be read from FLASH (may be a few
seconds delay).
Battery Charger Settings, where user can select when charging is allowed. Charge
on need or charge after ignition ON. If device is configured to charge battery after ignition is on,
charger can be enabled after ignition is turned on, except if battery is fully charged or 10 minute
26