Debug Mode - Teltonika FM1000 ST User Manual

Setparam # # Set parameter value according entered ID and Value.
1.# – ID value.
2.# – New Parameter Value
flush Initiates all data sending to specified target server
#,#,#,#,#,#,# 1. # – IMEI
2. # – APN
3. # – LOGIN
4. # – PASS
5. # – IP
6. # – PORT
7. # – MODE (0 – TCP; 1 – UDP)
sn x [x=0;1] Enable/disable static navigation
banlist Banlist information
crashlog Crash log information
delete_all_sms Delete all read SMS
braminfo BatRam info
getgnss Current GNSS information
resetlimits Resets data counters
ATTENTION!
In order to send these commands, they have to be converted to special format.
How to convert to this format and for additional information on how to send
GPRS commands, please contact to your local sales representative.

8 Debug mode

FM1000 is able to transmit its current state when connected to PC using USB cable. It is
used to detect errors and provide information to possible solutions when operating as
unexpected. Download Terminal from:
http://avl1.teltonika.lt/Downloads/Software/Terminal.zip.
After launching terminal choose baud rate 115200 and hardware control – none. Select
COM port which is assigned to "Virtual COM Port". Click on 'Start Log' button and save a new file.
Enable DTR and then click 'Connect' to start receiving messages from FM1000 .
Also you can log NMEA data directly. To get NMEA data, simply enter the following
command into the command field: .log_nmea:1$0a.
55