Start Speed (Id=1281); Ignition Off Timeout (Id=1282); Distance Mode (Id=1283); Trip Continuous Distance Counting - Teltonika FM1000 ST User Manual

Minimum Maximum
value value
0 2

9.6.22 Start Speed (ID=1281)

This parameter represents speed, which is detected as minimum speed to indicate TRIP
START and generate event.
Minimum Maximum
value value
0 255

9.6.23 Ignition Off Timeout (ID=1282)

This parameter represents timeout to wait if ignition is off in order to detect TRIP STOP and
generate event.
Minimum Maximum
value value
0 65535

9.6.24 Distance Mode (ID=1283)

This parameter defines how and from what data source driven distance is counted.
Possible values are: 0 – between records (from GPS), 1 – continuous (from GPS) (default), 2 –
continuous (from OBD).
Minimum Maximum
value value
0 2

9.6.25 Trip Continuous distance counting

This parameter removed from FM1000 firmware version >00.06.xx. Odometer is always
counting distance continuously (from Trip start to Trip stop) when Distance Mode parameter is
set to continuous.

9.6.26 Odometer Value (ID=1284)

Minimum Maximum
value value
0 999999

Geofencing

In this chapter it is explained how to get all parameters for the first Geofence zone (all ID
numbers are for the 1
with the IDs of all the rest Geofence zones.

9.6.27 Frame Border (ID=1020)

Geofence border thickness, measured in meters.
Recommended
value
-
Recommended
value
-
Recommended
value
-
Recommended
value
-
Recommended
value
-
st
zone). And at the end of the chapter (part 8.6.10) is presented a table
Goes with (depends on)
parameters
Goes with (depends on)
parameters
Goes with (depends on)
parameters
Ignition Source (ID=1003)
Mode Switch Source (ID=1002)
Trip (ID=1280)
Goes with (depends on)
parameters
Goes with (depends on)
parameters
Trip (ID=1280)
Value
type
U8
Value
type
U8
Value
type
U16
Value
type
U8
Value
type
U16
73