Table of Contents
Advertisement
5.9.4 Movement Event
Movement Event functionality makes an eventual high priority record (and sends an optional SMS)
when device is stationary or in motion (depending on configured "Mode") for set Timeout (added to
"Movement Start/Stop Delays" accordingly).
Timeout is a configured amount of time (in seconds) after which an eventual high priority record is
generated.
Note: this timeout is added with Movement Start Delay if configured Mode is Movement Event or
with Movement Stop Delay if configured Mode is No Movement Event.
Movement Event mode generates a record after the start of movement whereas No Movement
Event generates a record after the stop of movement.
5.10 AutoGeofencing settings
AutoGeofence is based on the last known position after the movement has stopped. You
can be notified using this feature if the object has left the generated zone. The size of Geofence
zones are set by parameters. AutoGeofencing options can be configured by following parameters
as depicted in Figure 19 below.
AutoGeofence zone is generated immediately within set Radius value around tracker's
most recent position, when Auto Geofencing is enabled over Keyboard. Scenario can also be
activated through a SMS/GPRS command and can be disabled by SMS/GPRS, configured button
or a call. To disable Auto Geofencing scenario with a call, configure Incoming Call Settings to
Auto Geofence Off
and set authorized numbers if such are used.
Note that AutoGeofencing does not require entering coordinates, instead it requires GPS
visibility.
Figure 19 Movement Event parameters
37
Advertisement
Table of Contents
