Faultcodes; Towingreact; Gprs Commands - Teltonika FM1000 ST User Manual

Example:Protocol:5,VIN:N/A,TM:5,CNT:5,ST:OBDDATA
REQUESTING,P1:0x0,P2:0x0,P3:0x0,P4:0x0,MIL:0,DTC:0,ID0

6.1.21 faultcodes

Response details
LIST
Example: "P0100,P0200,P0300,C0300,B0200,U0100".

6.1.22 towingreact

Reactivates Towing Detection to initial state (does not wait for ignition to be OFF). Useful
when generated false Towing event and needs reactivation.

7 GPRS commands

It is possible to send commands to FM1000 using GPRS. When FM1000 sends records
periodically to a server, a message could be sent from the server and FM1000 will reply to it.
FM1000 has to be connected to the server in order to receive commands.
Command
#GET DATAORDER
#SET DATAORDERX=Y
#GET RECTO
#SET RECTO=X
#GET VERSION
#GET NETWORK
#GET IMSI
#DO REPORT
#DO RESET=XXX
#GET ROAMINGX=Y
#SET ROAMINGX=Y,Z
#GET REMIPX
#SET REMIPX=Y:Z
#GET AUPX
#SET AUPX=Y,Z,W
#GET REPRTX
#SET REPRTX=Y
#GET REPDISTX
#SET REPDISTX=Y
Description
Returns list of fault codes; response when no faults: "No fault
codes detected."
Description
Get info about records sorting parameter
Set records sorting parameter, X – profile, Y – value (0/1).
Get info about records refresh timeout parameter
Set records refresh parameter, X = records refresh timeout
Receive firmware version
Get GSM operator to which device is connected
Get IMSI of the device
Save a record
Reset FM5302 or GPS module, XXX – FM5X or GPS
Get operator from the list of a certain profile, X – profile, Y – operator
number in a list
Set operator to the list of a certain profile, X – profile, Y – operator
number in a list, Z – operator code
Get IP and port number from the configuration of a certain profile, X –
profile
Set IP and port number to the configuration of a certain profile, X – profile
no, Y – IP or domain, Z – port number
Get APN, user login and password from the configuration of a certain
profile, X – profile
Set APN, user login and password to the configuration of a certain profile,
X – profile, Y – APN, Z –, user login W – password
Get MinPeriod from the configuration of a certain profile, X – profile
Set MinPeriod to the configuration of a certain profile, X – profile, Y –
MinPeriod value
Get MinDistance from the configuration of a certain profile, X – profile
Set MinDistance to the configuration of a certain profile, X – profile, Y –
53