Software
There are two major software components to monitor and control the Ethernet Reference
Design System:
•
GUI/Client Application
•
MicroBlaze Processor Server Application
Figure 5-9
shows these components.
X-Ref Target - Figure 5-9if
GUI/Client Application
A Java-based GUI/Client application running on the control computer communicates with
the MicroBlaze Processor Server Application through a UART interface to control test
parameters, collect statistics, and display current status of the design.
The GUI displays the following information:
•
Current mode of operation
•
Payload size
•
Throughput numbers and graphs when a test is executing
•
10-Gigabit Ethernet MAC IP statistics
•
Power consumption and temperature for the FPGA
•
Block diagram of the design
10GBASE-KR Ethernet TRD
UG1058 (v2017.1) April 19, 2017
GUI/Client Application
Control Computer
Figure 5-9: Software Components
www.xilinx.com
Chapter 5:
UART Interface
Server Application
Microblaze Processor on KCU1250 Board
Reference Design Details
X18487-120716
76
Send Feedback