Revision History - Xilinx KCU1250 10GBASE-KR User Manual

Revision History

The following table shows the revision history for this document.
Date Version
04/19/2017 2017.1
12/15/2016 2016.4
11/28/2016 2016.3
10/12/2016 2016.3
06/08/2016 2016.2
04/13/2016 2016.1
11/23/2015 2015.4
10/02/2015 2015.3
06/30/2015 2015.2
04/27/2015 2015.1
03/04/2015 2014.4.1
10GBASE-KR Ethernet TRD
UG1058 (v2017.1) April 19, 2017
Updated for Vivado Design Suite 2017.1. Updated design file
rdf0310-kcu1250-trd05-2017-1.zip. Updated sections
Forward Error Correction. Added a note about screens in
Updated for Vivado Design Suite 2016.4. Updated design file
rdf0310-kcu1250-trd05-2016-4.zip.
Changed rdf310-kcu1250-trd05-2016-3.zip file name to
rdf0310-kcu1250-trd05-2016-3.zip.
Updated for Vivado Design Suite 2016.3. Re-added
Design. Updated Appendix D, Additional Resources and Legal
Replaced all references to Vivado Design Suite version 2016.1 with version 2016.2.
Replaced all references to Vivado Design Suite version 2015.4 with version 2016.1.
Replaced all references to Vivado Design Suite version 2015.3 with version 2015.4.
Replaced all references to Vivado Design Suite version 2015.2 with version 2015.3.
Replaced all references to Vivado Design Suite version 2015.1 with version 2015.2.
Added step c, page 23 under
step 2, page 39.
Replaced all references to Vivado Design Suite version 2014.4.1 with version 2015.1.
added [Ref 1] to the to the first listed item under
Quad Transceiver names in
Bulls Eye Cables, page 19. Updated the Quad Transceiver names in
Updated step 4, page 20. Updated screen capture in
content in the VIO_Tab column in
hw_vio_6 > hw_vio_1. Updated screen captures in
Figure 3-11, Figure 3-18, Figure
in the VIO_Tab column in
Initial Xilinx release.
www.xilinx.com
Revision
step 6, page 23. Added new
Hardware, page
step 1 and TX and RX cable names in
Table 3-1 from hw_vio_1 > hw_vio_6 to
Figure
3-19, and Figure 3-20. Revised the order of content
Table 3-2.
Configure VIO and
Install Vivado Design
Chapter 3, Bringing Up the
Notices.
step 2, page 25 and new
10. Updated the
step 2 under Connect
Figure 3-1.
Figure 3-8. Reversed the order of
3-9, Figure 3-10,
Send Feedback
Suite.
2