Running the Design
Launch the Ethernet Controller Application
1. Launch the Ethernet Controller application GUI on the control computer. In Windows,
click Start > All Programs > Xilinx > EthernetController
X-Ref Target - Figure 3-12
2. Select the COM port associated with the Silicon Labs CP210x USB-to-UART
Bridge: Standard COM Port and click Connect
Controller application for the 10GBASE-KR TRD.
The COM port associated with the Silicon Labs CP210x USB-to-UART Bridge: Standard COM Port
TIP:
can be identified using the Windows device manager. See
X-Ref Target - Figure 3-13
Figure 3-13: Select COM Port Associated with the USB-to-UART Bridge
10GBASE-KR Ethernet TRD
UG1058 (v2017.1) April 19, 2017
Figure 3-12: Launch Ethernet Controller Application
www.xilinx.com
Chapter 3:
Bringing Up the Design
(Figure
3-12).
X18452-120716
(Figure
3-13) to open the Ethernet
step 4, page
13.
X18453-120716
Send Feedback
31