Table of Contents
Advertisement
Setup
This chapter lists the requirements and describes how to do all preliminary setup of the
KCU1250 board, control computer, and software before bringing up the 10GBASE-KR TRD.
Perform the procedures described in this chapter before performing the bring up
IMPORTANT:
procedures described in
Requirements
Hardware
•
KCU1250 board with the Kintex® UltraScale™ XCKU040-2FFVA1156C FPGA
•
Two USB cables, standard-A plug to micro-B plug
•
Power Supply: 100 VAC–240 VAC input, 12 VDC 5.0A output
•
Backplane: Z-Pack TINMAN Customer System kit from Tyco Electronics
•
Two Samtec Bulls Eye® cables from Avnet
•
Four DC Blocks/AC capacitors from Aeroflex
Computer
One computer is required, and is identified as the control computer throughout this
document. It is required for running the Vivado® Design Suite, configuring the FPGA, and
running the Ethernet Controller application GUI to control and monitor the reference
design. It can be a laptop or desktop computer with Microsoft Windows 7 Operating
system.
Design Tools and Software
•
Vivado Design Suite 2017.1
•
USB UART drivers (CP210x VCP drivers)
•
Tera Term
[Ref 7]
10GBASE-KR Ethernet TRD
UG1058 (v2017.1) April 19, 2017
Chapter 3, Bringing Up the
[Ref 6]
www.xilinx.com
Design.
[Ref 4]
[Ref 5]
Chapter 2
[Ref 2]
[Ref 3]
10
Send Feedback
Advertisement
Table of Contents
