Xilinx KCU1250 10GBASE-KR User Manual page 12

Configure the Control Computer COM Port
The TRD uses the Tera Term Pro terminal emulator and the Ethernet Controller application
GUI to communicate between the control computer and the KCU1250 board. To configure
the control computer COM ports for this purpose:
1. Place switch SW1 to the OFF position. (SW1 in
2. Connect the KCU1250 board to the control computer and power supply as shown in
Figure 2-1.
Figure 2-1 shows only the top edge of the KCU1250 board
TIP:
X-Ref Target - Figure 2-1
Board
Power
Switch SW1 J28 12 VDC
OFF
ON
3. Power on the KCU1250 board by placing switch SW1 to the ON position. (SW1 in
Figure 2-1).
10GBASE-KR Ethernet TRD
UG1058 (v2017.1) April 19, 2017
Power Supply
100VAC–240VAC Input
12 VDC 5.0A Output
Figure 2-1: Connections for Preliminary Setup
www.xilinx.com
Figure 2-1).
.
Wally
J1
USB UART USB JTAG
Send Feedback
Chapter 2: Setup
USB cable
standard-A plug
to micro-B plug
To U80
X18427-120716
12